Hookah box

Hookah Box Set Up Instructions:
1. Fill the base with water through the large hole at the top of the box. Fill base half way.
2. Using the small rubber insert, attach the hose to the box, make sure that it is air tight. Attach
the black stem to the opposite side of the hose.
3. Now that your hookah is air tight, pack the bowl with some tobacco. Fill the silicone bowl to
the top leaving a flat top layer. Do not place tobacco in the center of the bowl, leaving the
holes uncovered. Do not pack the bowl too tight for it will make it harder to inhale and will
not allow the tobacco to burn properly.
4. Once the bowl is packed and ready to go place it in the large hole on the top of the base.
5. Now that your hookah is connected and your bowl is properly packed, light up 3 pieces of
charcoal, wait for them to turn red and place them inside the metal heat management system
6. Using the bottom rubber grip, carefully place the metal heat management on top of the bowl
7. Wait 3 minutes then start taking a series of rapid small pus to get the tobacco burning. You
will know that it is burning properly once smoke starts to build up in the base of the hookah
and starts to flow easily through the hose.
8. After you have completed all of these steps you should be on your way to a pleasant hookah
smoke session.
9. Before refilling your bowl with tobacco be sure coals are carefully removed using tongs and
deposed of in cold water. Wait 10 minutes for metal to cool then repack your bowl and repeat
the above listed steps.
10. If you are having trouble with any of these steps contact us by text or call (725) 755-1512